Compared with the traditional air conditioning terminal, the cold beam system is a more economical and environmentally friendly choice. Primary air interface is mainly used to eliminate indoor wet load and ensure indoor fresh air, through the induction nozzle to make indoor air into the coil, and mixed with the primary air into the room, to achieve greater cold heat output.
CDKA induced cold beam can meet the indoor comfortable environment requirements of a variety of occasions, especially can be used for primary air cooling heat can not meet the indoor load requirements of the room. CDKA induced cold beams can not only be used for new buildings, but also for old buildings.
Optional 2 control or 4 control system;
High induction ratio, large cooling and heating power;
No fan, quiet energy saving;
The equipment height is low, can be used for low and high floors;
Combined with cold ceiling system to eliminate peak load;
It can be installed either explicitly or secretly.
Klimakontor CDKA overall dimensions
1 | The total length (mm) | 1195 | 1495 | 1795 | 2195 |
2 | Total width (mm) | 296 | 296 | 296 | 296 |
3 | Total height (mm) | 271 | 271 | 271 | 271 |
4 | Diameter of primary air interface (mm) | 98 | 98 | 98 | 98 |
5 | Number of primary air interfaces (one) | 1 | 1 | 2 | 2 |
CDKA induction cold beam installation can be carried out in sequence, can be any number of splicing, including the installation of the first section, the middle section, the end, in addition to achieve the visual effect of indoor environment, can only install the shell, do not install heat exchanger.
